EC3 RC Battery Connector Cap Cover Charge Status Indicator Charged Dead Storage

Description

This listing is for a complete set of
16 covers
for the
EC3 Connector
, enough for 5 battery packs or more.
Ever charge a battery or remove one from a charger and put it in a group of battery and don't remember witch one it is? Even worse take off with a dead battery thinking it was charged, and it wasn't because it was mixed up with the charged batteries without being charged. This should solve that problem by adding the appropriate cover.
$$ BUY MORE SAVE MORE $$
What you get:
5 ea. Green Covers
5 ea. Yellow Covers
5 ea. Red Covers
1 ea.  Gray Cover
C Green Cover
is for
C
harged
S Yellow Cover
is for
S
torage (3.8v per cell)
D Red Cover
is for
D
ischarged
? Gray Cover
is for a questionable battery (may be bad)
How to use:
When you remove the battery from the charger install the
C Green Cover
for
C
harged. When installing in your Truck, Buggy ,Quad, Heli, or Aircraft remove the
C Green Cover.
When finished with the battery install the
D Red Cover.
If you
don't
plan on
using
your lipo batteries for
awhile
it is best for them to be in a state of storage charge of 3.8v per cell. Use the
S Yellow Cover
after the battery is set to storage voltage. Have a battery that is causing problems that you are just not ready to trash yet? That is what the
? Gray Cover
is for. NOTE: if the cap is slightly loose or tight rotate it 180 deg. and try again.
Know at quick glance what charge state the battery is in.
Prevents posable short circuit from connectors touching other batteries in storage and transporting.
Keeps the electrical connections of the connector clean.
Reuse over and over.
Made in the USA using 3D printing
technology
Biodegradable,
consists of renewable raw materials and is biodegradable in industrial composting plants.